: +86-532-82195788 / +8613589360799
         :  ivy.su_1984@qdxkjx.com    
Qingdao Xinke Machinery Technology Co., Ltd
You are here: Home » News » Filter element change method

Filter element change method

Views: 0     Author: Site Editor     Publish Time: 2019-01-08      Origin: Site

1. When we begin to discharge filter element, should from the service port of filter top, prevent dust escaping from lower service port.

2. Screw the button by anticlockwise direction, discharge service port door.

3. Remove filter element,peel off sealing cushion between filter element and filter base plate sealing face.Slowly move filter element 1/2 location. Let all the dust fall out from top of filter, take out from front service port of filter.

4. Dont tap filter element which not to be fall down on floor or other hard surface, if filter element broken, will be air leakage.

5. Check the store situation of wast dust, clean out in time.

6.For insure sealing cushion is reliably,we must add lining plate around service port.Cleaning all the waste-dust with each filter element cover and service port door.







Leave a Message
Contact Us
Warmly welcome to visit 'Qingdao Xinke Machinery Technology Co., Ltd'. Our company
was established in 2010, with a registered capital of 30 million RMB. Its predecessor is Qingdao Doublestar
Foundry Machinery Co., Ltd's branch factory.
Copyright © 2017Qingdao Xinke Machinery Technology Co., Ltd, All Rights Reserved